Journal
We bring to your attention an article devoted to the production and market of cement in Azerbaijan, as well as to the role of the largest cement produ...
| Issue №6, 2006 |
| Section: Review |
| Keywords: building sector, Garadagh Cement |
A method is suggested for prevention of damage to roller mill drives with a low rotation speed. The method is based on the use of slider bearings with...
| Issue №6, 2006 |
| Section: Equipment and technology |
| Keywords: Helmke, roller mill, drive power |
| Autor: B. Mathiaszyk. |
Over the last three decades the vertical roller mill has become the preferred mill for grinding of raw materials. The grinding efficiency of the verti...
| Issue №6, 2006 |
| Section: Equipment and technology |
| Keywords: mill flow, product quality, dehydration of gypsum, operating cost, support, cost |
| Autor: S. W. Jorgensen. |
Positive dynamics of development in cement sector saved in October and November. 2006. The data on cement and clinker output by the country's ente...
| Issue №6, 2006 |
| Section: Ukrainian pages |
| Keywords: test |
The article cites the results of practical application of the working method of determination (slick method) of the p-quartz content in raw ma...
| Issue №6, 2006 |
| Section: Control of production |
| Keywords: Oskol-Cement, silicon oxide, raw materials, rate accuracy, volume of quartz |
| Autor: E.V. Tekucheva, A.A. Drozdov, G.A. Zinovieva. |
The article analyzes the status of gas dedusting in the basic technology equipment in the industry of construction materials, including cement industr...
| Issue №6, 2006 |
| Section: Ecology and safety |
| Keywords: Fingo, ecological engineering |
| Autor: V.N. Chumakov. |
The article discusses the prospects of technologies of secondary fuel combustion. It cites examples of the technical solutions in that area developed ...
| Issue №6, 2006 |
| Section: Waste utilization |
| Keywords: cost improvment, secondary fuel, bypass, technology |
| Autor: M. Mersmann. |
The article cites the results of the work on the determination of optimum quantity of melted spinel introduced into the charge in order to increase th...
| Issue №6, 2006 |
| Section: Science and production |
| Keywords: aluminic additives, tensile strength, periclase-spinel redractory |
| Autor: V.I. Shubin, V.P. Migal, S.I. Gershkovich, A.P. Margishvili, V.V. Bulin. |
The article discusses the types of wear of journal roller bearings and bandages of rotary cement kilns, reasons that cause such wear and problems that...
| Issue №6, 2006 |
| Section: Equipment and technology |
| Keywords: kiln, surface abrasion, bandage |
| Autor: W. Gebhart. |
An MPS 3750 C mill supplied by Gebr. Pfeiffer AG was the world's first vertical roller mill to be used for finish-grinding cement. The plant went ...
| Issue №6, 2006 |
| Section: Equipment and technology |
| Keywords: vertical roller mill, flow sheet, field data |
| Autor: Y. Reichardt. |