Journal
Cement factory Krasnoselskstroymaterialy upgraded its existing two-chamber mill with the installation of new internal elements, including the lining o...
| Issue №6, 2010 |
| Section: Equipment and technology |
| Keywords: ball mill; diaphragm; grinding media; grinding efficiency |
| Autor: U. Karsunke. |
The design and operation of a new vertical MVR roller mill system by Pfeiffer is described. Operating parameters of grinding plants with mills of this...
| Issue №6, 2010 |
| Section: Equipment and technology |
| Keywords: roller mill; grinding plant; modular construction; power consumption |
| Autor: Y.C. Reichardt. |
In India the first Loesche six-roller raw mill was successfully commissioned at Tadipadri in the cement plant owned by the second largest cement produ...
| Issue №1, 2009 |
| Section: Equipment and technology |
| Keywords: mills sizes, productivity, fineness |
| Autor: M. Keissner, P.S. Matsumdar. |
The article is devoted to the technologies and equipment used for diminution of solid domestic and industrial wastes at preparation of alternative fue...
| Issue №1, 2009 |
| Section: Equipment and technology |
| Keywords: fuel handling, milling stages, shredder, alternative fuel |
| Autor: O.N. Kaygorodov. |
The article describes the industrial laser diffraction analyser MYTOS that provides representative sampling, dispersion of the sample and changing the...
| Issue №1, 2009 |
| Section: Control of production |
| Keywords: particle size, milling, analyzers, sampling |
| Autor: A. Pankewitz, T. Hubner, D. Tausenev. |
The article presents the results of operating Russia’s largest closed-cycle cement mill produced by FLSmidth (Denmark) and installed at OAO Se...
| Issue №2, 2009 |
| Section: Equipment and technology |
| Keywords: Sebryakov-Cement, mill, installation operation, break-in, productivity |
| Autor: S.P. Rogachev. |
The article discusses the problems of replacing the geared drive of a ball mill at a cement plant, the causes and complexities of the problems, as wel...
| Issue №3, 2009 |
| Section: Equipment and technology |
| Keywords: drivers change, reducing gear, ball mill |
| Autor: A.G. Troshina. |
The article considers the designs of single- and double-roll hammer mills for crushing and drying of materials. It provides the operating characterist...
| Issue №4, 2009 |
| Section: Equipment and technology |
| Keywords: hammer mill, usage sample, design, drying |
| Autor: A. Groyne, E. Holling, H.-D. Cybulsky, A.I. Kondrashov. |
On the basis of a well proved modular concept, Loesche Company has developed the world`s largest raw vertical roller mill with six rolls. Such a mill ...
| Issue №4, 2009 |
| Section: Equipment and technology |
| Keywords: 6-hi mill, equipment characteristic, configuration |
| Autor: M. Keyssner, R. Krammer, P.S. Mazumdar. |
The article presents the results of the works on conversion of two cement mills to the closed grinding cycle. It points out the unconventional positio...
| Issue №5, 2009 |
| Section: Equipment and technology |
| Keywords: grinding mill, modernization |
| Autor: H-U. Schaefer. |