Journal
The article considers the conditions for storage, loadings and unloading of cement manufacture materials by using large-volume silos. Two versions of ...
| Issue №5, 2009 |
| Section: Equipment and technology |
| Keywords: silos, unloading, bearing |
| Autor: H. Buschmann. |
One of the technological problems faced practically by all cement plants is the reception and selection of materials discharged from under railway car...
| Issue №5, 2009 |
| Section: Equipment and technology |
| Keywords: Aumund Foerdertechnik GmbH, conveyor, reception of materials |
| Autor: N. Velten. |
The article presents the results of the works on conversion of two cement mills to the closed grinding cycle. It points out the unconventional positio...
| Issue №5, 2009 |
| Section: Equipment and technology |
| Keywords: grinding mill, modernization |
| Autor: H-U. Schaefer. |
The article describes high-porosity paper for Quick-Fill-type bags developed by the Swedish company Billerud Sack Solutions. It also discusses technic...
| Issue №5, 2009 |
| Section: Equipment and technology |
| Keywords: high-porosity paper, technical consulting, packing |
| Autor: M. Peterson. |
The article describes a project involving block lining for the vault of a rotary kiln grate cooler. A special feature of the vault design is the use o...
| Issue №5, 2009 |
| Section: Refractories |
| Keywords: refractory facing, cooling, clinker, air-quenching cooler |
| Autor: Yu.L. Goloperov, V.V. Barinov, A.A. Kondrukevich, I.V. Pyrkova, A.Yu. Popov, A.V. Sharonov. |
The article considers solutions suggested by FLSmidth Automation that are directed at remote maintenance of the equipment and make it possible to opti...
| Issue №5, 2009 |
| Section: Automation of production |
| Keywords: FLSmidth, ECS / ProcessExpert System, finish grinding mill, auto-start, remote monitoring |
| Autor: J. Jacob. |
The article describes the results obtained after introduction of the Expert Optimizer system, which operates in the anticipatory management mode to co...
| Issue №5, 2009 |
| Section: Automation of production |
| Keywords: Expert Optimizer system, decarbonizer, alternative fuels |
| Autor: T. Marx, M. Holpert, B. Wolf. |
The article cites the results of development and introduction of automated process control systems (APCS) at ZAO Nevyansky Cementnik. Introduc...
| Issue №5, 2009 |
| Section: Automation of production |
| Keywords: APCS, clinker burning, compressor plant, milling |
| Autor: N.Yu. Egorov. |
The article considers the possibilities and effectiveness of application of the calorimetric analysis method for studying the technological process ch...
| Issue №5, 2009 |
| Section: Standartization and quality |
| Keywords: calorimetric analysis, heat liberation |
| Autor: A.V. Usherov-Marshak, V.P. Sopov. |
The cohesion of cement grains is caused by surface forces acting between calcium silicate hydrate (C-SH) nanoparticles in interstitial electro...
| Issue №5, 2009 |
| Section: Science and production |
| Keywords: mathematic simulation, electrolyte solution, cohesion, cement-water paste |
| Autor: A. Nonat, I. Pochard, C. Labbez, C. Plassard,, E. Lesniewska, B. Jönsson.. |