Journal
The paper describes the work on the architectural design of the preheater tower at the cement plant of Lafarge Cement in Wössingen, Germany. It i...
| Issue №3, 2011 |
| Section: Equipment and technology |
| Keywords: architecture, preheater tower, landscape |
| Autor: T. Bogaert. |
Operation of vertical roller cement mills for autonomous grinding plants with no water injection is reviewed, which enables them to work without heat ...
| Issue №3, 2011 |
| Section: Equipment and technology |
| Keywords: vertical roller mill, grinding plant, water injection, hot gas generator |
| Autor: D. Strohmeyer. |
Pilot tests of InCem E 500 grinding intensifier by OOO Sintez OKA – Intensiv at ZAO Ulyanovsk-Cement confirmed its efficacy for open cycle cement grin...
| Issue №3, 2011 |
| Section: Equipment and technology |
| Keywords: cement mill, open circuit, grinding intensifier, specific surface, power consumption |
| Autor: E.V. Zvyagintsev, S.I. Savilov, R.M. Gainutdinov. |
With FLEXIFLAME burners from GRECO, already installed at factories in France, Belgium, Italy, England and Denmark, the expenses on fossil fuels can be...
| Issue №3, 2011 |
| Section: Equipment and technology |
| Keywords: burner, primary air, fuel, flame |
| Autor: C. Helmreich. |
The solutions of German VAKOMA® Company for ball mill drives are discussed. The company offers opportunities for both repair and modernization of old ...
| Issue №3, 2011 |
| Section: Equipment and technology |
| Keywords: drive, gear, ball mill, modernization |
| Autor: H. Blossfeldt, A. Gshibowski. |
The design of rubber lining for raw material and cement mills, produced by OAO UrRTI is discussed. The advantages of using rubber and rubber magnetic ...
| Issue №3, 2011 |
| Section: Equipment and technology |
| Keywords: rubber lining, rubber-magnetic lining, lifter |
| Autor: V.G. Maslennikov, A.Y. Stikhin. |
The article describes the experience of improving the equipment for cement production, in particular, ball mill thrust bearings, based on the achievem...
| Issue №3, 2011 |
| Section: Equipment and technology |
| Keywords: mechatronics, control, hydraulic system, ball mill, bearing |
| Autor: P.S. Zbožinek, O. Ožana. |
The article discusses the use of various alternative fuels, their properties, as well as the negative impact of fuel on the refractory lining, anchor ...
| Issue №3, 2011 |
| Section: Refractories |
| Keywords: alternative fuel, refractory lining, silicon carbide, zirconium dioxide |
| Autor: V. Bolimov, A. Klemba. |
The influence of water-to-cement mass ratio (w/c) on early-age properties of cement-based materials is investigated using a variety of experim...
| Issue №3, 2011 |
| Section: Science and production |
| Keywords: compressive strength, hydration, water-to-cement mass ratio, calorimetry, crack formation |
| Autor: D.P. Bentz, M.A. Peltz, J. Winpigler. |
The article addresses the problem of energy efficiency through combining low-melting mixes of raw materials and commercial development of cement produ...
| Issue №3, 2011 |
| Section: Science and production |
| Keywords: non-traditional raw materials, volcanic glass, kiln performance increase, hydraulic activity |
| Autor: Z.P. Pulatov, E.M. Butayev. |