Journal
Continuous kiln availability for a period of one year or even higher is a prerequisite for achieving high production target in a cement plant. In the ...
| Issue №3, 2012 |
| Section: Refractories |
| Keywords: cement kiln, refractories, corrosion |
| Autor: S.K. Chaturvedi, M.M. Ali, A. Pahuja. |
Construction of new cement plants, modernization of existing facilities with the introduction of automated control systems make high demands on the le...
| Issue №3, 2012 |
| Section: Automation of production |
| Keywords: training complex, training, cement production |
| Autor: Y.N. Kireyev. |
The structural model of alite was made more exact, and polymorphic modifications of belite for clinkers from Russian cement plants were redefined acco...
| Issue №3, 2012 |
| Section: Control of production |
| Keywords: clinker, alite, X-ray phase analysis, X-ray structure analysis |
| Autor: P.S. Chizhov. |
The requirements for instruments used in determining the dispersion and particle size distribution of granular and powdered materials, potential and s...
| Issue №3, 2012 |
| Section: Control of production |
| Keywords: grain distribution, vibrating screen, Blaine apparatus, laser particle analyzer |
| Autor: I.S. Lisitsyna, A.V. Gerasimov. |
The effect of limestone and dolomite additives on the properties of composite cements: water demand, setting time, consolidation deformation, the cont...
| Issue №3, 2012 |
| Section: Science and production |
| Keywords: composite Portland cement, carbonate supplements, slow setting, the products of hydration, strength, corrosion resistance |
| Autor: V.K. Kozlova, A.M. Manokha, A.A. Likhosherstov, E.V. Manuilov, E.Y. Malova. |
A review of recent research, developing further the understanding of kinetics and mechanism of C3S hydration, and the microstructure and the crystal l...
| Issue №3, 2012 |
| Section: Science and production |
| Keywords: hydration of C3S, C—S—H phase, microstructure, morphology, nanogranular structure |
| Autor: A.I. Vovk. |
The effect of water-cement ratio (W/C) on the kinetics of heat release during hydration of cements with different mineralogical composition ha...
| Issue №3, 2012 |
| Section: Science and production |
| Keywords: cement hydration, rate of heat release, water-cement ratio, compound composition |
| Autor: A.A. Serdyukova, I.S. Rakhimbayev. |
The influence of polymer additives in the form of polymer dispersions and redispersible polymer powders on the technical characteristics of oilwell Po...
| Issue №3, 2012 |
| Section: Special binders |
| Keywords: oil-well Portland cement, polymer additives |
| Autor: S.A. Kataev, Y.R. Krivoborodov, D.V. Nazarov, A.A. Glushkov. |
A project to use waste as fuel by installing a Vecoplan FuelTrack equipment at the Cimentos Molinos Industrial factory, Spain, is described. The desig...
| Issue №3, 2012 |
| Section: Waste utilization |
| Keywords: cement plant, waste utilization, alternative fuels |
| Autor: F. Griera, G. Lopez, W. Zschiesche. |
As a result of the lead thermodynamic calculations the most probable ways of course of reactions hardening developed in slag-alkaline binding material...
| Issue №3, 2012 |
| Section: Waste utilization |
| Keywords: slag-alkaline binding material, flinty material, steel-smelting slag, thermodynamic analysis, hydration |
| Autor: M.V. Tamazov, I.G. Dovzhenko, A.M. Kondyurin, V.V. Vereshchaka, N.A. Tamazova. |