Journal
On September 21-23, the Loesche Company held a technical workshop in Moscow to exchange experiences on Optimization of grinding technology and qualifi...
A system for process automation at the Achinsk Cement plant, owned by BaselCement holding company, set up after the plant was out of operation from 20...
| Issue №6, 2011 |
| Section: Automation of production |
| Keywords: automation, process, cement production |
| Autor: A.A. Meshcheryakov. |
A method for finding the kinetic parameters of the clinker grinding process in closed-circuit ball mills is proposed, which allows construction of sev...
| Issue №6, 2011 |
| Section: Science and production |
| Keywords: closed circuit ball mills, circulating load, kinetics of the grinding process, particle size distribution |
| Autor: V.S. Bogdanov, R.R. Sharapov, D.V. Bogdanov. |
The RHI Company cement and lime department has developed a number of services for technical support of cement and lime production. The services includ...
| Issue №1, 2010 |
| Section: Refractories |
| Keywords: RHI, refractory, manufacturing process, kiln |
| Autor: V.V. Kovalev, V.V. Korneev, R. Krischanitz. |
The article cites the results that enabled envisioning the process of cement clinker production as a single structure formation process accompanied by...
| Issue №1, 2010 |
| Section: Science and production |
| Keywords: structure formation, basic material, technological process |
| Autor: E.N. Potapova, L.M. Sulimenko. |
The subject of this article is energy saving by burning various alternative fuels in cement kilns, technological, ecological, economic and social prob...
| Issue №2, 2010 |
| Section: Waste utilization |
| Keywords: со-processing; waste; alternative fuels; energy-efficiency |
| Autor: J.-M. Chandelle. |
The article reports on three projects implemented with the participation of A TEC Company, Austria in the Republic of Belarus and describes various st...
| Issue №3, 2010 |
| Section: Equipment and technology |
| Keywords: cement production; project; managing quality; process line |
| Autor: W. Gigacher, P. Laube. |
Various methods and their classification variants are considered for Portland cement clinker manufacture based on chalk as the raw material. Possibili...
| Issue №4, 2010 |
| Section: Equipment and technology |
| Keywords: chalk; slurry; wet, semi-wet, semi-dry, dry process; rotary kiln; cyclone preheater; modernization of cement industry |
| Autor: M. Kapphahn. |
The article describes hot-gas generator furnaces operating on coal and used in drying processes. Under analysis are special features of vertical furna...
The article describes the sequence of the development and introduction of an automated system of quality control and laboratory. It shows the effect o...
| Issue №4, 2010 |
| Section: Control of production |
| Keywords: automated process control system (APCS), information transparency, control of technological norms, coordination of technological and parametric control of cement production |
| Autor: E.V. Tekucheva, S.A. Bezlepkina, D.A. Kudryashov. |