Journal
Cement factory Krasnoselskstroymaterialy upgraded its existing two-chamber mill with the installation of new internal elements, including the lining o...
Issue №6, 2010 |
Section: Equipment and technology |
Keywords: ball mill; diaphragm; grinding media; grinding efficiency |
Autor: U. Karsunke. |
The article discusses the problems of replacing the geared drive of a ball mill at a cement plant, the causes and complexities of the problems, as wel...
Issue №3, 2009 |
Section: Equipment and technology |
Keywords: drivers change, reducing gear, ball mill |
Autor: A.G. Troshina. |
The paper deals with issues of suction in closed cycle cement ball mills, and its effect on the kinetics of the process of grinding. A computational m...
Issue №5, 2012 |
Section: Science and production |
Keywords: aspirational mode, ball mills, closed circuit, disperse composition |
Autor: V.S. Bogdanov, R.R. Sharapov, O.I. Bazhanova, R.R. Sharapov Jr.. |
The solutions of German VAKOMA® Company for ball mill drives are discussed. The company offers opportunities for both repair and modernization of old ...
Issue №3, 2011 |
Section: Equipment and technology |
Keywords: drive, gear, ball mill, modernization |
Autor: H. Blossfeldt, A. Gshibowski. |
The article describes the experience of improving the equipment for cement production, in particular, ball mill thrust bearings, based on the achievem...
Issue №3, 2011 |
Section: Equipment and technology |
Keywords: mechatronics, control, hydraulic system, ball mill, bearing |
Autor: P.S. Zbožinek, O. Ožana. |
This paper describes the changeover of the OAO Holcim (Rus) plant to the dry process. In particular, the grinding equipment was upgraded and ...
Issue №4, 2014 |
Section: Equipment and technology |
Keywords: cement ball mill, gear, upgrade |
Autor: M. Beсhler, A. Troshina, D. Gostevsky. |
The new grinding plant from Christian Pfeiffer, Germany, was commissioned at OAO IvanoFrankovsk-Cement. Due to a high demand for cement in Ukraine the...
Issue №3, 2013 |
Section: Equipment and technology |
Keywords: cement grinding, ball mill, open circuit, close circuit |
Autor: M. Halbur, A.G. Demkiv, N.V. Makoviychuk. |
The paper proposes a method for reducing specific energy consumption by cement grinding in ball and tube mills (BTM). The results after modern...
Issue №3, 2013 |
Section: Equipment and technology |
Keywords: aspiration system, cement grinding, centrifugal filter, cement ball mill |
Autor: V.V. Gorgolyuk, D.A. Serebryansky, D.L. Anikin. |
The experience of the Zlatoust Metaplast foundry (ZLZ Metaplast) in upgrading the steel liner plate design in ball mills is described. A new l...
Issue №5, 2013 |
Section: Equipment and technology |
Keywords: liner plate, ball mill. |