Journal
The article reviews the advantages and disadvantages of the currently applied methods of determination of compatibility of cement with surfactant addi...
Issue №3, 2007 |
Section: Application of cement |
Keywords: additives, modifiers, superplasticizer, portland cement |
Autor: T.M. Petrova, A.F. Serenko. |
The article presents the results of an investigation of the hydrophobic cement obtained by adding a water-repelling admix. A study was made of the adm...
Issue №4, 2007 |
Section: Science and production |
Keywords: energy saving, hydrophobicity, research, additives |
Autor: A.P. Butenko, I.G. Luginina. |
The article provides information on the International conference on dry construction mixes (September 12–14, St. Petersburg, Russia).
Issue №5, 2007 |
Section: Conferences, seminars, exhibitions |
Keywords: Baltimix, reports, dry construction mixes, chemical additives |
Autor: Yu.V. Nikiforov.. |
The aim of the article is to analyze the way of decreasing specific energy consumption in cement production on the trritory of Ukraine.
Issue №5, 2007 |
Section: Science and production |
Keywords: energy saving, fuel consumption, national regulations, mineral additive |
Autor: A.D. Gavryushin, A.I. Zdorov, M.Sh. Fayner, S.I. Darchuk, V.S. Melentieva. |
This article describes the results of cement com- posites nanomodifier research. The strength and water impermeability increasing were achieved with u...
Issue №5, 2007 |
Section: Science and production |
Keywords: nanoadditives, calcium silicate hydrate, cement stone, zeolite |
Autor: A.S. Korolev, E.Sh. Khakimova, D.V. Makridin, E.A. Voloshin. |
The article considers the efficiency of influence of some organic additives on the cement production process, cement handling, storage as well as on i...
Issue №1, 2008 |
Section: Science and production |
Keywords: grinding efficiency, additive, intensificators, production expenses |
Autor: V. Sumner. |
The article gives the results of the commercial tests on the production of mechanically and chemically activated cements of low water demand at a high...
Issue №3, 2008 |
Section: Science and production |
Keywords: mechanochemical activation, mineral additives, manufacture |
Autor: M.Ya. Bikbau, V.N. Mochalov, Chen Lun. |
The influence of mineral additives – waste ash and slag from Verkhnetagilskaya TPP and granulated blast furnace slag from OAO Nizhny Tagil Metallurgic...
Issue №5, 2011 |
Section: Waste utilization |
Keywords: waste ash and slag, mineral additive, concrete |
Autor: F.L Kapustin, D.V. Ragozin, A.V. Kuznetsov, V.A. Klevakin, I.S. Semerikov, A.F. Kapustin. |
The effect of the modifying sulfoaluminoferrite (SAF) additive on the composition and structure of the products formed in the process of hydro...
Issue №5, 2011 |
Section: Concrete |
Keywords: hydrosilicate hardening, structure, sulfoaluminateferrite additive, chemical reinforcing, ironsubstituted hydrosilicates of calcium, autoclave aerated concrete |
Autor: A.A. Mechai, E.I. Baranovskaya. |
The study examines the effect of silica-containing additives – microsilica, white soots and colloidal silica – on calcium concentration, pH value and ...
Issue №1, 2010 |
Section: Science and production |
Keywords: additives, silica, dispersity, calcium, supersaturating |
Autor: A.S. Brykov, R.T. Kamaliev. |