Journal
A new design of three-stage WPV gearboxes from FLSmidth MAAG Gear with bevel and planetary stages, equipped with sleeve bearings, made the unit very c...
| Issue №4, 2011 |
| Section: Equipment and technology |
| Keywords: gearbox, mill, bearing. |
| Autor: K.U. Moesli. |
The range of grinding equipment and services offered by Austrian company CEMTEC Cement and Mining Technology GmbH for cement, mining and processing in...
| Issue №4, 2011 |
| Section: Equipment and technology |
| Keywords: grinding, mill, cement |
| Autor: F. Plochberger. |
Equipment by HAZEMAG & EPR GmbH, Germany, designed for drying of inorganic materials while simultaneously grinding them, is discussed. Case studies of...
| Issue №4, 2011 |
| Section: Equipment and technology |
| Keywords: dryer, mill, crusher, fly ash, clay |
| Autor: H.-D. Zibulski. |
The impact of Litoplast I grinding intensifiers, developed by OOO Polyplast Novomoskovsk, on the performance of industrial cement mills, the unit cost...
| Issue №4, 2011 |
| Section: Science and production |
| Keywords: grinding intensifier, cement mill, unit cost of electric power |
| Autor: L.D. Shakhova, S.V. Markova, D.A. Mishin. |
The paper describes the results of the analysis of ground raw materials moving on the air slide made with SpectraFlow inline analyzers controlled by t...
| Issue №2, 2015 |
| Section: Control of production |
| Keywords: SpectraFlow online analyzer, nearinfrared technology, raw mill, LSF standard deviation |
| Autor: M. Erbaltaci, O. Oztürk, C. Potocan, D. Köberich. |
On September 25—26 in Duesseldorf, Germany LOESCHE Symposium 2014 was held. It was attended by more than 350 guests from 55 countries. An overview of ...
The paper describes the advantages of cement vertical roller mills OK from Danish FLSmidth. The data was obtained in the operation of this type of mil...
| Issue №4, 2014 |
| Section: Equipment and technology |
| Keywords: vertical roller mill, cement grinding |
| Autor: A.V. Matviychuk, P.E. Grydgaard, K.B. Hansen. |
This paper describes the changeover of the OAO Holcim (Rus) plant to the dry process. In particular, the grinding equipment was upgraded and ...
| Issue №4, 2014 |
| Section: Equipment and technology |
| Keywords: cement ball mill, gear, upgrade |
| Autor: M. Beсhler, A. Troshina, D. Gostevsky. |
The new grinding plant from Christian Pfeiffer, Germany, was commissioned at OAO IvanoFrankovsk-Cement. Due to a high demand for cement in Ukraine the...
| Issue №3, 2013 |
| Section: Equipment and technology |
| Keywords: cement grinding, ball mill, open circuit, close circuit |
| Autor: M. Halbur, A.G. Demkiv, N.V. Makoviychuk. |
The paper proposes a method for reducing specific energy consumption by cement grinding in ball and tube mills (BTM). The results after modern...
| Issue №3, 2013 |
| Section: Equipment and technology |
| Keywords: aspiration system, cement grinding, centrifugal filter, cement ball mill |
| Autor: V.V. Gorgolyuk, D.A. Serebryansky, D.L. Anikin. |