Journal
The article describes the improved design of a screw classifier. The essence of the problem and the importance of raw slurry classification are demons...
| Issue №5, 2015 |
| Section: Science and production |
| Keywords: classifier, sewage sludge, ball raw mill, milling, regrinding, solid sludge constituent, density, particle diameter, hydraulic resistance |
| Autor: V.S. Bogdanov, D.V. Bogdanov, N.E. Bogdanov. |
The article describes the main ideas and content of the seminar Current state and trends in the development of automated plants for cement and raw mat...
| Issue №3, 2007 |
| Section: Conferences, seminars, exhibitions |
| Keywords: automated complex, cement milling, equipment sampling |
| Autor: LG. Sudakas, A.B. Upolovnikov. |
The equipment, possessing a number of advantages of klinker grinding in comparison with a ball mill, is viewed in this article.
| Issue №2, 2007 |
| Section: Science and production |
| Keywords: milling, ball grinder, fineness of grinding |
| Autor: A.V. Artamonov, M.S. Garkavi, V.N. Kushka. |
The article characterizes laboratory mill RS 200 produced by Retsch Company and intended for preparation of hard, brittle и fibrous materials for anal...
| Issue №1, 2007 |
| Section: Control of production |
| Keywords: grinding, milling bowl |
| Autor: H. Neumann. |
The article considers the possibility of neutralizing to a considerable degree of coarse-grained – quartz, which is present in the raw material, by gr...
| Issue №1, 2008 |
| Section: Science and production |
| Keywords: milling, energy cost, fineness of grinding, homogenicity, raw mix |
| Autor: D.V. Smal, V.D. Barbanyagre. |
OAO Nikolaev-Cement, Ukraine, a member of the Lafarge Group, has ordered at Christian Pfeiffer Maschinenfabrik GmbH, Germany the design, equipment and...
| Issue №3, 2008 |
| Section: Equipment and technology |
| Keywords: Nikolaev-Cement, milling, engineering, new shop floor |
| Autor: H. Schaefer. |
The article is devoted to the technologies and equipment used for diminution of solid domestic and industrial wastes at preparation of alternative fue...
| Issue №1, 2009 |
| Section: Equipment and technology |
| Keywords: fuel handling, milling stages, shredder, alternative fuel |
| Autor: O.N. Kaygorodov. |
The article describes the industrial laser diffraction analyser MYTOS that provides representative sampling, dispersion of the sample and changing the...
| Issue №1, 2009 |
| Section: Control of production |
| Keywords: particle size, milling, analyzers, sampling |
| Autor: A. Pankewitz, T. Hubner, D. Tausenev. |
The article cites the results of development and introduction of automated process control systems (APCS) at ZAO Nevyansky Cementnik. Introduc...
| Issue №5, 2009 |
| Section: Automation of production |
| Keywords: APCS, clinker burning, compressor plant, milling |
| Autor: N.Yu. Egorov. |
The article cites the results of a mill equipment upgrading project executed at the OAO Iskitim-Cement plant by Spanish company Estanda. It is shown t...
| Issue №6, 2009 |
| Section: Equipment and technology |
| Keywords: milling capacity, energy intensity, grinding, thermal conditions |
| Autor: V.V. Aleynikov, V.E. Manuylov. |